Restoring the Imprivata Database from a Backup
If the Imprivata database becomes corrupt or otherwise compromised, restore it from a backup file.
Only a Super Administrator can restore the Imprivata database.
Restore the Imprivata Database from a Backup File
The restore operation stops Imprivata on the appliance where you start the restore. Other appliances remain online. During the restore, the Imprivata Appliance Console remains available for all online appliances, but you should not use those consoles until the restore is complete. The Imprivata Admin Console is unavailable during the restore.
To restore the Imprivata database:
-
Open the Imprivata Appliance Console to the System page > Operations tab.
-
In the Restore section, specify if the last successful backup should be used or if a different backup file must be uploaded.
-
Do one of the following:
-
If the last backup file is being used, click Restore.
-
Upload the required file, and click Restore.
If the backup file is encrypted, enter the password. The password field appears only if the backup file is encrypted. The encryption password is specific to the backup file and is independent of the Imprivata Appliance Console password.
-
-
Click OK.
Your browser might be sluggish during the restore. A progress indicator indicates how close the restore is to completion.
Allow the restore to finish. When the restore is complete. Enterprise Access Management restarts. You do not need to restart the appliance.
Synchronizing the Imprivata Database
Restoring the database automatically synchronizes the database appliances. Only database appliances contain an instance of the database.
Independent of a database restoration, you may need to synchronize the Imprivata database to fix a replication problem.
Synchronization can only be performed by a Super Administrator on a database appliance. Contact Imprivata Support for assistance with this procedure.
If you have a network device on which SQLNet inspection is enabled, Imprivata recommends that you disable SQLNet inspection before synchronizing the Imprivata database to prevent interference with inter-appliance communication.
To synchronize the Imprivata database on both database appliances in an enterprise:
-
Open the Imprivata Appliance Console to the System page > Operations tab.
-
Click Synchronize.
-
Click OK on the dialog box to begin synchronizing.
During synchronization, the Imprivata Admin Console remains available on all appliances. All appliances in the enterprise use the database on the appliance from which the operation was started. There is no service outage to Imprivata users.
The synchronization can take anywhere from 20 minutes to more than four hours. The duration depends mainly on the size of the Imprivata database, and particularly on the number of rows of audit log data in the database. The duration is also affected by the location of the two database appliances, with respect to each other. If the data has not finished copying from the source database to the target database within five hours, the operation times out and the synchronization fails.